Calibrate Your Printer from the Web Portal

Please calibrate your printer when loading new labels into your printer, or if you experience voids or shifting.


RF printers require two calibrations be completed, which include Media & Ribbon, and RFID.


Please make sure that your printer is unpaused before continuing.

To calibrate your printer, first log in to the Simple RFID Web Portal.


Click the Available Printers icon at the top-right of the page.


Locate the desired print station and click the Calibrate icon to the right.



Finally, click Calibrate to start the calibration process.


  • Accepting this prompt will then send both the media and ribbon and RFID calibrations to the printer, which will proceed automatically with the following steps:
    • Media and Ribbon.
    • Then a pause for roughly 10 seconds.
    • And then the RF calibration, which will take longer; the labels will periodically inch out of the printer for approximately one minute. At the end of the process it will feed out 2 or 3 labels before stopping completely.
  • After the calibration has completed:
    • Open the printer and roll back the labels so the blank tags may be used—precision is not necessary
    • Un-pause the printer
    • Now you are ready to print.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article